Two weeks ago we started to get the F06 fault code. We got it to work for a couple of weeks but it returned again. After much research and troubleshooting it appears to be either the MCU or the motor itself. I checked the wiring and all connections and it appears to be fine. I pulled the MCU and DO NOT see any obvious damage or burn marks. I also did the ohms check on the motor between pins 1-3, 1-2 and 2-3 and all were above the nominal resistance of ~6 ohms at between 8-9 ohms. Based on what I have seen online the tach ohms are good and I can see a rise and fall when I spin the motor. I was initially leaning towards replacing the MCU, but because the issue is intermittent I'm thinking that it may be the motor. Am I right to think that if it was the board that it would be bad all of the time, or could that cause an intermittent issue as well? Thanks for the help!
via Kenmore HE4t Intermittent F06
by Greydog65
No comments:
Post a Comment