GE front loader in cancelled mode and the pump keeps running.

Hello. I have a GE Front loader model GFW550SSNOWW. Somehow it ended up in cancelled mode on screen and the pump keeps running. I have unplugged overnight twice, plugged in, let run for 4 minutes per owners manual and nothing. let run for 20 minutes per a thread. I cleaned out drain hose, tub boot to drain, detergent compartment, inlet filters, strainer, door gasket, etc. i even ran water through it and it pumps. I can not utilize any function on the command pad. Can not really...

Read more

via GE front loader in cancelled mode and the pump keeps running.
by Krl82

Maytag Centennial MVWC200XW2 will not start/ lid lock flashing

I have the washing machine in the title, we bought it about 3 years ago, but it was used. It will light the "sensing" LED, some water will be start running, then the water stops and the "lid locked" light will start blinking. You can hear and feel the lock trying to latch.

At first, I could remove the red cover on the lid lock module (I'm not sure of the correct term) and toggle the rocker back and forth a few times, put it back together and it would run at least one cycle (sometimes 3 or...

Read more

via Maytag Centennial MVWC200XW2 will not start/ lid lock flashing
by LiveWire

F28 error on HE5t

Unplugging and waiting 10-15 minutes doesn't reset it.
I replaced the MCU about 11 years ago. - https://www.applianceblog.com/mainforums/threads/fixed-he5t-just-beeping.23867/#post-119786 which fixed a different issue.
My understanding is that F28 is the CCU, MCU or wiring between the two.
I've done a continuity test of the wiring between the CCU connector and MCU connector and the resistance looks pretty much spot on.

Is there a way to test the CCU and MCU to determine which is bad...

Read more

via F28 error on HE5t
by rover_nut

Maytag mvwb865gw0

I have replaced the door lock, the control panel and power supply and it still does not work.help!!!

via Maytag mvwb865gw0
by sts3717

Kenmore 110.25132410 Agitator Seal

My washer had spinning problems After hours of trying everything, I ended up using a Dremel to cut off the hub, and the metal washplate gear.

With all the abuse, I'm a little concerned about the agitator shaft seal and was hoping to replace it.

If possible, to hold off until after Christmas to get a new washer, so a new gearbox isn't worth it.

Does anyone know if just the seal alone can be replaced, and if so what is it's part number? No part number for my model is shown, since it...

Read more

via Kenmore 110.25132410 Agitator Seal
by ChesterD

Speed queen washer suddenly started making beeping sounds model AWN43RSN115TW01

Out of the blue my speed queen top load suddenly started a random beep. I hear just one beep and it may be awhile before I hear again. I unplugged last night and left unplugged over night. it is 4 mos shy of the 3 yr warranty. i heard it beep and the machine wasn't in use. any idea why? I didn't clean the inlet water filters every 6 months. I will do this tomorrow and call the manu but wanted to see what you think. It is TR3000WN. Other than this strange occurance it washes fine and no...

Read more

via Speed queen washer suddenly started making beeping sounds model AWN43RSN115TW01
by pbhardshell59