Whirlpool duet washer not draining

Have a whirlpool duet washer I acquired and have a problem. If I disconnect the internal drain tube from the top near the lid and let it lay out the back it drains perfectly and runs amazing. But if I have the hose connected where it should be the pump won't push the water up vertically and I get an error code. Not sure if I have a week pump or something else happening. Hose is not twisted or pinched when I have it connected. The first picture shows where it connects normally but I have the...

Read more

via Whirlpool duet washer not draining
by manupnorth

GE GUD27 washer leaking water

Washer quit on wash cycle yesterday with blinking wash light. Removed front panel and notice the bottom of washer has water in in. Plus a few socks. Error codes to Blocked Motor but everything spins freely. Cleaned up water, reset the machine, wash cycle again with panel off and noticed steady flow of water water leaking down from the shifter assembly. I'm assuming the drive seal is shot.
Was able to put the washer into Quick Rinse cycle with no water leaking, ran fine right through spin...

Read more

via GE GUD27 washer leaking water
by CrankyFrankE

mvw72332hw0 Maytag will not spin

mvw72332hw0-maytag-washer-will-not-spin-replaced-clutch-and-recalibrated-still-an-issue-would-like-to-confirm-if-main-control-board-is-the-problem.

via mvw72332hw0 Maytag will not spin
by Mkodsu

Old Maytag will not agitate, only spins. Pully turns ONE direction only

Spins fine, NO agitation.

Found washer full of water and not running. Advancing the control to the spin cycle and it spins and drains well. Will not wash (or rinse) because zero agitation.

I took off the belt, and the main pully spins by hand fine ONE direction. Totally locked the other. As in: Totally. Locked.
The pully pops out when turned in the spin direction, which I assume disengages the brake... seems to work (brake works when spin is interrupted by lifting lid.)

Is this a...

Read more

via Old Maytag will not agitate, only spins. Pully turns ONE direction only
by Ryder

Whirlpool Washer (Lsn1000lw0)

Hi there, I have a top-loaded Whirlpool washer that had a drum that wouldn't spin the water out of the clothes. It agitated fine, but the drum just wouldn't do the high or low spin. I bought and installed a new coupler and new clutch assembly (coupler was fine, just wanted to replace since I was removing motor). The clutch assembly replacement fixed the no-spin issue, but now I'm getting a repetitive noise during the spin and the agitation isn't working anymore. The lower agitator (and...

Read more

via Whirlpool Washer (Lsn1000lw0)
by Samps

Discussion: Sealant for spline / threads?

As the saying goes, "an ounce of prevention is worth a pound of cure."

I've just bought a used washing machine (Maytag MVWB765FW3) that had an issue with the door lock latch (F5E1). Electronics being a strong suit of mine I fixed the issue.
But I've now disassembled the machine into its base components for a thorough cleaning. After removing the agitator that was pretty well stuck on the spline, it got me wondering.

Are there any goops or substances I could put on the spline to prevent...

Read more

via Discussion: Sealant for spline / threads?
by BAM5

GTW330ASK2WW loud squeal during agitation only, can manually replicate

Very loud squeal/squeak during agitation only, I can pause the cycle and manually twist agitator a tiny bit and make the sound. Should I remove agitator tower or is it obviously another issue? Thanks for any input.

via GTW330ASK2WW loud squeal during agitation only, can manually replicate
by Estea

FFFW5100PW0 auto temp lights keeps blinking simultaneously

Hi There,

My Frigidaire Affinity washer auto temp lights are blinking without any cause. As soon as i select a program the auto temp lights start to change from temperature (running up and down) This also happens during a washing cycle. what can i do?

Please help

via FFFW5100PW0 auto temp lights keeps blinking simultaneously
by ilonka

Kenmore 970-C98802-00 clicks off and on at beginning of agitation

The washer that came with my condo new, is showing its age, but money is tight. A new combo washer dryer is $2,000. Can’t afford it.

When it starts each agitation cycle, it clicks on and off rapidly for 5 seconds, then it’s fine. It is getting worse. I’ve seen that this can be motor or the close door sensor, but my close door sensor hasn’t functioned since I bought the condo 5 years ago.

Recommendations are greatly appreciated! The dryer also squeaks terribly when it starts, until it...

Read more

via Kenmore 970-C98802-00 clicks off and on at beginning of agitation
by Byro

Maytag stuck on cycling not sensing F6e3

MOD:MW7232HWO
SER: CX2303779
MayTag Commercial Technology
My Maytag washer is stuck on cycle mode and not sensing ? When I run a component activation diagnostic I get a F6E3 error code when I run the unbalance detection I get the F6 E3 error code my, LED light is flashing correctly so I just need to replace the control board ACU

via Maytag stuck on cycling not sensing F6e3
by appzsapp

Kenmore 110.29732800 not draining

Kenmore 700 series top load washer, model number 110.29732800 is not draining properly. The machine does spin and begin to drain but does not finish it, was thinking could be a clogged drain line but haven’t found a video of how to disassemble. Any help is appreciated.

via Kenmore 110.29732800 not draining
by mlj32

GTW460BMK0WW personality code

Hello all.
Ive got new board for this washer ww01f01729 no where to find its personality code.
Please help!

via GTW460BMK0WW personality code
by Toddbutcher

No lights, not working

I have a Maytag Centennial washer and I came home to no lights, not starting. Completely dead. There is power to the outlets. Thank You

via No lights, not working
by JesusFreak

Huebsch Washer TR5104WN

Huebsch 6 cycle 3.2 CUFT,820 RPM Commercial
i bought machine March 1 because i thought a commercial washer would last longer. i live in canada and paid 1800.00. it started making a noise 2 weeks ago on agitation (like a ping pong game being played) Repair man told me today he is replacing gear box. Already? I was told this machine is made by Speed Queen and was an awesome machine. It’s brand new and has not been abused. Is this normal? Anyone ever hear of this? This machine has...

Read more

via Huebsch Washer TR5104WN
by Chris102602

Washer doesn’t spin

Maytag model mhwc7500ywo doesn’t enter spin cycle, except when it does, every few loads. I’ve replaced the door lock and MCB and the machine still only spins sometimes. UDT shows no errors, QDT shows F20, sometimes, which isn’t listed in the service tech doc.
I live in a tropical climate and electrical connections corrode much faster than in N. America so I’m at the point of stripping it down and checking/cleaning contacts.
Any other suggestions?

via Washer doesn’t spin
by Myller

WAT28401UC/17 Bosch Washer 500 Series Power Cord Too Short

I just bought a brand new Bosch 500 Series washer to replace a Bosch Axxis + washer. I have a Bosch Axxis + dryer that still works. The washer is 220V and connects to the dryer using a proprietary plug. The plug is too short to reach the socket in the dryer. I have seen that the Bosch 500 Series dryer is the same, so I would run into exactly the same issue if I purchased a new dryer. I would like to retain the current configuration, rather than purchase a stacking kit.

Preferably, I have...

Read more

via WAT28401UC/17 Bosch Washer 500 Series Power Cord Too Short
by CBenn

Leaks Over Top Of Tub

Working on a LAT2500AAE washer. It leaks water when in the drain cycle over the top of the tub. It seems the force of the spin is making the water run up the sides then over the top. I took the drain belt off and it was worn but not too bad. If I change out the pump and belts will it drain better and then keep this from overflowing the top? Or could there be an issue with the transmission slipping or something that could be a bigger problem? Not sure if I should recommend replacing or...

Read more

via Leaks Over Top Of Tub
by JimmyMas

Speed Queen Loud noise wile agitating.

Loud noise wile agitating.

via Speed Queen Loud noise wile agitating.
by Shaneshelley234

GE Washing Machine turns on by itself

Hi, i am currently having issues with my GTW460ASJ4WW washer. In the middle of the night while we were sleeping, the washer turned itself on. No water was coming into the machine or anything. Just was a buzzing noise. The only way to get it to stop it to unplug it. Any ideas on what it could be before purchasing a new control board? Thanks for any help!

via GE Washing Machine turns on by itself
by CodySmith88

F6E2 error code on Maytag MHW5630hwo

I was washing 2 light blankets when I received a F6E2 error code. I ordered a whole new control panel, but after replacing it the error code was still present. The power button will not work. It will go into diagnostic mode, but not sure what to do after. All connections look fine and I have a green light on one of the other boards (main control?). Not sure what to test or replace at this point.

via F6E2 error code on Maytag MHW5630hwo
by sengra