GE stackable GUD24ESSJ0WW

Where is the drain trap/filter on the washing machine?

via GE stackable GUD24ESSJ0WW
by nikkirporter

Help finding a washing machine with a Hand Wash cycle

We had a Whirlpool Cabrio wtw7800 that has finally died. It has been on its last legs for over a year but my wife didn't like anything else she could find because she couldn't find something with a Hand Wash cycle. She found a Kenmore 26132 that describes the Delicate cycle as " This cycle uses intermittent wash action with cool water and slow spin to gently care for fine washables" She said this will work but will take a while to get. Anything else out there have a "Hand Wash" cycle...

Help finding a washing machine with a Hand Wash cycle

via Help finding a washing machine with a Hand Wash cycle
by sprtfan

Maytag front loader

My Maytag front loader washer is leaking from the bottom and it pretty much turns into a puddle of water on the ground and leak is coming from the hose that the water uses in rinse cycle. Please help me fix thank you hope to hear back from you soon because my garage is getting flooded as we speak from the water thats coming out of my washer underneath

via Maytag front loader
by Andromeda

Need a belt

I have a kenmore washer 110seirs model 13202200 i need a belt but dont no what part numbers is really dont want to take all apart without having one any help would be great thanks

via Need a belt
by Sterlin40

washer heat booster

Question on how these heaters actually work.
Customer said the water was not getting hot. The unit is getting hot water. the heat booster is getting 120v but the water is not getting hot. Checked this in diagnostic mode in which the unit fills, tumbles, and turns the heater on. The heater has continuity and ohms out correctly. And as mentioned was getting 120v, while in diagnostic mode. Checked power coming off the board and at the heater. I left it in this mode for quite a few minutes to...

washer heat booster

via washer heat booster
by Mcnabb75

Wf42h5200aw/a2 main board Dc92-01621D , DC92-01803C

My washer came with the DC92-01803C and was having some intermittent issues so I decided to change the board . Contacted Samsung and they told me a Dc92-01621D was an updated board for this model . I ordered it an pit it in . The board would flash red . I tried to power on the washer . No power . I put the old board back in and it is flashing green and the washer powers on. I do not believe these are interchangeable as Samsung says . Looks like other people have run into this. I want to know...

Wf42h5200aw/a2 main board Dc92-01621D , DC92-01803C

via Wf42h5200aw/a2 main board Dc92-01621D , DC92-01803C
by pltmann50@gmail

LG all in one washer/dryer WM3997HWA no power

Stopped working mid dry cycle. No power when you press power button.
I tried a reset suggested by LG (holding power 5 seconds, then start for 5 seconds), didn’t work
I confirmed the outlet works.
I confirmed there is power going through the power cable.
I replaced the noise filter assembly.
Still doesn’t work.
Did discover that if I spin the tub by hand that all of the lights on the display board light. And it initially gave the code PF. I pushed the power button while spinning the tub and...

LG all in one washer/dryer WM3997HWA no power

via LG all in one washer/dryer WM3997HWA no power
by jojowasher

HISENSE HWFE7510 drain pump won't stop running

Drain pump will not stop running? Any ideas

via HISENSE HWFE7510 drain pump won't stop running
by Jutt

Ge front load washer pause load

Hello having issues getting into service mode for ge front load washer model gfwh1200. any suggestions as the signal, delay wash, signal, delay wash not working for me. thank you

via Ge front load washer pause load
by chadcchadc

Worn Out Drive Belt?

Clothes are kind of wet after the final spin, wet enough to prompt a complaint. I never really had a reason to notice how fast it used to spin during the final spin before the problem started, but my wife thinks it's not spinning as fast. Maybe because I asked her, "Does it seem like it's not spinning as fast as it used to?" Anyway, I remember the whole thing would really shake during the final spin, and it doesn't seem to do that any more.

And there has definitely been a smell of...

Worn Out Drive Belt?

via Worn Out Drive Belt?
by HammerAndTongs