Speed Queen Washer AWN432SP111TW01 not draining properly

My Speed Queen AWN432SP111TW01 has not been spinning the clothes out very well and it seems to have gotten worse this past use. My clothes are still soaked and I’m having to wring them out by hand. I do notice a very faint burnt rubber smell after the spin cycle. Any advice on what’s possibly wrong or does anyone know if there’s a manual out there so I can take the washer apart myself to troubleshoot.

via Speed Queen Washer AWN432SP111TW01 not draining properly
by KellyT0915

SpeedQueen AWN432SP111TW01not draining properly

My SpeedQueen AWN432SP111TW01 has not been spinning the clothes out very well and it seems to have gotten worse this past use. My clothes are still soaked and I’m having to wring them out by hand. I do notice a very faint burnt rubber smell after the spin cycle. Any advice on what’s possibly wrong or does anyone know if there’s a manual out there so I can take the washer apart myself to troubleshoot.

via SpeedQueen AWN432SP111TW01not draining properly
by KellyT0915

GE stackable GUD24ESSJ0WW Washer won't enter diagnostics

My GE stackable won't enter diagnostics mode. I've followed the instructions on entering diagnostics several times and it won't work. Problem is it fills with water but won't enter wash mode.

via GE stackable GUD24ESSJ0WW Washer won't enter diagnostics
by aircrisp@gmail.

GE stackable GUD24ESSJOWW won't enter diagnostics

My GE stackable won't enter diagnostics mode. I've followed the instructions on entering diagnostics several times and it won't work. Problem is it fills with water but won't enter wash mode.

via GE stackable GUD24ESSJOWW won't enter diagnostics
by aircrisp@gmail.

2016 Speed Queen Washer AWN432SP113TW04 won't agitate if there is any load on agitator. Can grab agitator and stop it.

2016 Speed Queen AWN432.

If agitator has any load on it...IE clothes to push around...it just stalls.
If you are only moving water, it works fine.
Cycles and spins fine.

Not sure if it is related, but there is a slight noise in 2nd video.

Take a look and see what you think.
I use this machine at an animal-rescue and need to get her going ASAP or call a repairman if it is a difficult job.
Thank you for any insights.

Speed Queen agitator problem

2 new photos added to shared album

photos.app.goo.gl

...

Read more

via 2016 Speed Queen Washer AWN432SP113TW04 won't agitate if there is any load on agitator. Can grab agitator and stop it.
by Roadcase

2016 Speed Queen Washer AWN432 won't agitate if there is any load on agitator. Can grab agitator and stop it.

2016 Speed Queen AWN432.

If agitator has any load on it...IE clothes to push around...it just stalls.
If you are only moving water, it works fine.
Cycles and spins fine.

Not sure if it is related, but there is a slight noise in 2nd video.

Take a look and see what you think.
I use this machine at an animal-rescue and need to get her going ASAP or call a repairman if it is a difficult job.
Thank you for any insights.

Speed Queen agitator problem

2 new photos added to shared album

photos.app.goo.gl

via 2016 Speed Queen Washer AWN432 won't agitate if there is any load on agitator. Can grab agitator and stop it.
by Roadcase

2016 SQ432 won't agitate if there is any load on agitator. Can grab agitator and stop it.

2016 Speed Queen AWN432.

If agitator has any load on it...IE clothes to push around...it just stalls.
If you are only moving water, it works fine.
Cycles and spins fine.

Not sure if it is related, but there is a slight noise in 2nd video.

Take a look and see what you think.
I use this machine at an animal-rescue and need to get her going ASAP or call a repairman if it is a difficult job.
Thank you for any insights.

Speed Queen agitator problem

2 new photos added to shared album

photos.app.goo.gl

via 2016 SQ432 won't agitate if there is any load on agitator. Can grab agitator and stop it.
by Roadcase

Ge washer. Replaced board. Think I’m on wrong personality

I replaced the board. I have read many of the posts but whenever I try to change the personality it isn’t working. I think I need the “4”
Setting. The board fit perfectly and was told it is the right one. The new board is wh22x32357. Washing machine gtw485asj0ws

via Ge washer. Replaced board. Think I’m on wrong personality
by Mdellatore

Whirlpool washer not filling or draining

Ran a load of laundry, went to empty when it was done but the laundry was still wet. Ran another drain cycle. Went to take laundry out after that cycle, still soapy. Tried to just re-run the load and barely any water is coming out to fill the basin. Took all the hoses off, no blockage. Water is running.
Doesn't seem to be clogged.
Tried adding some water to just rinse clothes and spin, now it won't even spin. Just makes a noise.

via Whirlpool washer not filling or draining
by CruiseLizzie

Maytag washer mvwc565fwo.

The washer will agitate but it's slow and don't move the clothes. All the Cycles do work. And it does spin out good. Any help I appreciate it thanks alot.

via Maytag washer mvwc565fwo.
by Dalejrfan8

GE gtup240em5ww won’t agitate or spin

My GE stackable w/d had the complete tub assembly replaced about 4 years ago. Recently it began intermittently not spinning, and now will not agitate either. It seems to move thru the cycles (fill and drain ) and the motor is warm ( not hot ). The lid latch clicks and light goes red. I reset everything with the 6 lid open and close, and turned selector to spin and it did a spin cycle. On the on 2nd attemp, back to not agitate or spin. In diagnostic mode, when I turn to 3 o’clock position, no...

Read more

via GE gtup240em5ww won’t agitate or spin
by Senorrob

W6022 ASKO front-load washer doesn't unlock door at end of cycle.

ASKO model W6022 type WM25.1 front-load washer does everything properly but does not unlock the door at the end of the cycle. Also, all error lights are on at end of cycle but are not blinking. Clothes are spun out but door still stays locked. Door can be unlocked by pushing the unlock button so door is working. All other functions of the washer work properly.

via W6022 ASKO front-load washer doesn't unlock door at end of cycle.
by dashriprok

ASKO front-load washer doesn't unlock door at end of cycle.

ASKO model W6022 type WM25.1 front-load washer does everything properly but does not unlock the door at the end of the cycle. Also, all error lights are on at end of cycle but are not blinking. Clothes are spun out but door still stays locked. Door can be unlocked by pushing the unlock button so door is working. All other functions of the washer work properly.

via ASKO front-load washer doesn't unlock door at end of cycle.
by dashriprok

AGAIN POSTED IN WRONG FORUM but can't delete

Hi - Displays all common signs; select cycle, push start, close door...beeps as if door isn't shut. Test door latch while closed and all LEDs blink indicating door is not shut. Door latch and control board have both been replaced. Service LED on board blinking 2x every three seconds, indicating unit in delay start? Assuming delay is the door being "open"? Either way, I'm stuck with no more solutions that I can find.

*EDIT* Found thread below with almost exact scenario/actions taken...

Read more

via AGAIN POSTED IN WRONG FORUM but can't delete
by TFM

GE GDT665SSN2SS Won't Start

Hi - Displays all common signs; select cycle, push start, close door...beeps as if door isn't shut. Test door latch while closed and all LEDs blink indicating door is not shut. Door latch and control board have both been replaced. Service LED on board blinking 2x every three seconds, indicating unit in delay start? Assuming delay is the door being "open"? Either way, I'm stuck with no more solutions that I can find.

via GE GDT665SSN2SS Won't Start
by TFM

Whirlpool WTW5000DW1

I’ve checked the fault codes which are low fill and lid lock. My issue is when in the sensing mode it runs forever and then no other lights display and the drain cycle. The machine bypasses the wash cycle altogether. I have had this machine for 2 years and just started this problem.I have noticed it will drain and spin and I have checked all the hoses and screens with no obstructions or leaks. What else can it be.

via Whirlpool WTW5000DW1
by Sarge505

Whirlpool WTW4915EW1 Help

I have a whirlpool WTW4915EW1 washer and yesterday my wife noticed it didn't start, I unplugged the washer and plugged it back in and got a cycle to start but even during filling I noticed it seemed to be pulsing unusually (and lights were dimming with it). I ran the diagnostics but can't remember now what the codes were because now it won't even let me into diagnostics, when I plug it in I hear relays clicking on the control board every few seconds but it doesn't let me do anything. Any...

Read more

via Whirlpool WTW4915EW1 Help
by tabb9512