I got in a Whirlpool Carbrio washer. The drive belt was stretched and worn and had covered the underneath in black gunk. I figured the belt was the issue and replaced it. I started the washer up and there are a few symptoms.
First it seems to slip occasionally on some of the spinning.
I am not sure if its normal but just before each time it goes to drain it makes a grinding noise.
The oddest thing was just after the spin cycle had finished, it completely filled the washer half full of water on the normal cycle before I finally shut it off. There are so many symptoms I don't know where to start with this one.
Ran diagnostics and came up with these......
F7E5
F7E1
F0 E2
F2 E1
First it seems to slip occasionally on some of the spinning.
I am not sure if its normal but just before each time it goes to drain it makes a grinding noise.
The oddest thing was just after the spin cycle had finished, it completely filled the washer half full of water on the normal cycle before I finally shut it off. There are so many symptoms I don't know where to start with this one.
Ran diagnostics and came up with these......
F7E5
F7E1
F0 E2
F2 E1
via Whirlpool Cabrio Washer filling with water after spin cycle.
by BGT Masters of Tiki D
No comments:
Post a Comment