Hoping for some last minute information. I have a Maytag Neptune washer, model MAH6700AWW. It has been displaying error code E3. In my research, E3 is either the control panel or the Hall Sensor. The drum moves without any problem. Motor works, etc. The error code is displayed at the beginning of the Rinse/Spin cycle. A lot of sites mentioned checking the connections and wiring harnesses. The other day I opened it up and did that. I plugged the machine back in and started a wash cycle. It worked just fine. During the second load, the error code popped up. I unplugged it, let it sit for 15 minutes, plugged it back in and started a new cycle which worked just fine. This happened 2 more times where unplugging it apparently reset the error code and I was able to finish the cycle. Any thoughts on what might be causing this and what I can do to remedy it??? If the Hall Sensor or control panel needs to be replaced, I don't think it's worth it as I can purchase a whole new washer for $200 more. Thanks in advance for any help or insight you can provide!
via Maytag Neptune Error Code E3
by Matt6
No comments:
Post a Comment