I’m having problems with my washer. If I put in a small load of clothes, the washer will not complete the wash cycle. It will get to the point of spinning out the water, spins for a bit then it will stop and then the display begins to blink. After a couple of minutes the pump starts up like it’s going to start to spin then it will shut off after about 10 seconds and the start/stop cycle continues. It's strange though, if I put in a large load, the washer will work just fine. I’ve ran it through the diagnostic procedure and it complete that with no errors at all. I’m stumped as to what the problem may be. I’ve replaced the computer with a known good one and it does the same thing. I have not tested the motor or MCU yet. Any ideas?
via GHW9100LW1 spin issues
by Ethan Grier
No comments:
Post a Comment