Hi - I suspect I may have a imminent component failure on my Kenmore 700 series washer.
About every 20 loads, the load will not spin out, although the agitator is fine and the water does drain. It is similar to the issue described in this thread, just far more intermittent.
Could this situation also occur if insufficient water amount is used for a load? I ask because it seems to happen on the Low and Low/Med water level settings.
Thoughts?
About every 20 loads, the load will not spin out, although the agitator is fine and the water does drain. It is similar to the issue described in this thread, just far more intermittent.
Could this situation also occur if insufficient water amount is used for a load? I ask because it seems to happen on the Low and Low/Med water level settings.
Thoughts?
via Washer intermittently not spinning
by andyman1970
No comments:
Post a Comment