During a cycle my washer stopped and displayed Lr for Locked Motor - Motor not being see by the control board. After taking out the clothes, draining, and starting over it runs a cycle without spinning, but does not display the Lr code.
I entered diagnostics mode cleared the excessive help and diagnostics codes, and ran a quick service cycle. The cycle would not finish, but kept displaying SC (Service Cycle).
Diagnostics Codes were empty, but the Help codes read code 8 (During start up the motor did not reach 10 rpm within 2 seconds - informative only).
I accessed Outboard Test, and tried Motor Control and nothing happened. Nothing showed up on Help or Diagnostic codes.
What should I check next? Is the motor control and motor gone?
I entered diagnostics mode cleared the excessive help and diagnostics codes, and ran a quick service cycle. The cycle would not finish, but kept displaying SC (Service Cycle).
Diagnostics Codes were empty, but the Help codes read code 8 (During start up the motor did not reach 10 rpm within 2 seconds - informative only).
I accessed Outboard Test, and tried Motor Control and nothing happened. Nothing showed up on Help or Diagnostic codes.
What should I check next? Is the motor control and motor gone?
via Maytag Neptune - Washer will not spin: Prior Lr code, now Help code 8
by ZachZimmerman
No comments:
Post a Comment