Our washer recently stopped working. My wife had been using it in spin only mode when it stopped working. It then would allow the door to lock shut and the time would count down but would not spin. I tested it in other modes but it did the same thing. I ran the diagnostic and got an E56 error. I did all the tests, found the ohm reading at the motor was within range and spun freely so I replaced the control board and the door lock mechanism. I then tested it and the unit ran as it was supposed to. After finishing its cycle I tried it again and it was back to doing the same thing as before. Out of frustration I shook the machine, oddly it began to run again. This made me think it was harness related. I shook it again and the unit stopped and will not run again. I've made sure the connections are tight but I cannot getting it working. HELP!
Matt
Matt
via Frigidaire Affinity buzz but does not cycle
by Matt Fey
No comments:
Post a Comment