My maytag mah9700aww stopped draining this morning. I opened the back and there is no power to the pump. If it matters, the washer is a series 18.
I checked the voltage between CN5 Pin 1 and CN10 pin 6 and it is 120v. It is 120 even if the pump is not supposed to be on. I have gone into diagnostic mode, and I can hot and cold water on, etc, but when I try to tufn on the drain pump, nothing happens.
Any ideas?
I checked the voltage between CN5 Pin 1 and CN10 pin 6 and it is 120v. It is 120 even if the pump is not supposed to be on. I have gone into diagnostic mode, and I can hot and cold water on, etc, but when I try to tufn on the drain pump, nothing happens.
Any ideas?
via MAH9700AWW no power to drain pump
by Cbarown
No comments:
Post a Comment