It started out not spinning the water out of my clothes. I ran diagnostics and it said lid switch was bad so i replaced it. Then when i started it the lid lock light was on and diagnostics said the pump was bad so i replaced it. The lid lock light is still on and it will not run a cycle and will not let water in or anything. It just sits and kind of makes a grinding noise. I ran diagnostics again and the spin light and lid lock are on and the code is saying the actuator is bad. I cannot get it to do a calibration and i do not know how to clear the codes after a repair.
via Kenmore VMW
by safetyt
No comments:
Post a Comment