Hi all,
I believe this is pretty much a general question. I'm helping a friend fix his stacked Kenmore Laundry Center Washer.
Since the trans is out I'm wondering if the bottom shaft should turn if I attempt to rotate with an open end wrench. It doesn't.
This is the short shaft end at the bottom of the machine where the motor pulley attaches.
Thanks!
I believe this is pretty much a general question. I'm helping a friend fix his stacked Kenmore Laundry Center Washer.
Since the trans is out I'm wondering if the bottom shaft should turn if I attempt to rotate with an open end wrench. It doesn't.
This is the short shaft end at the bottom of the machine where the motor pulley attaches.
Thanks!
via General transmission question
by NJRick
No comments:
Post a Comment