I think I'm running out of options with this code. Code should be unbalanced load. Washer seems to fully function in all modes except final spin. The drum will start to spin, stop and then try to spin again and stops. Water does seem to drain (none left in drum). I have changed the washplate, it was bad-teeth worn badly. Still had same code. Washer is level and all feet were on the floor. Still got F0E5. Replaced the suspension rods and springs, problem continues. Also, replaced the drive belt. Checked the drive pulley and there is no damage. When doing the calibration mode, washer vibrates violently--only time it does this. Finally, the last thing I checked was the drive pulley and the new belt was split and there was belt "dust" below the motor pulley in the shield. Any help out there?
via whirlpool F0 E5 error code
by rickv
No comments:
Post a Comment