Hello
I have recently replaced the drum bearings and seal on my AEG w1460 washer. I admit I must have done it late... very late. when I took it apart the bearings were all seized up and ground to powder. I got them out with great difficulty, and put the machine back together. When I turned it to spin, ooo... what a difference... probably didn't work like that when it was new. But when I turned it to wash, after 30 seconds of filling, it started beeping, the drain pump turned on, and the end light turned on. checked all the wiring and pressure switch tubing and all little thingamabobs. I thought it was the heater but on rinse it does the same thing. Funny thing: when I disconnect the heating element, it will just fill until... well it just fills until I stop it or it overflows and does nothing else. well, during the last wash before the bearing service someone mentioned that the area around the circuit board got too hot. I pulled the board and found a lot of soot around some kind of transformer. the core of the transformer was cracked. I dug all over the internet for that transformer but I cannot find it. it is a hartu 716278-51. the board is an electrolux ewm1000. any help with finding the specs of the transformer or problem would be appreciated. I will post some pictures shortly.
Thanks
I have recently replaced the drum bearings and seal on my AEG w1460 washer. I admit I must have done it late... very late. when I took it apart the bearings were all seized up and ground to powder. I got them out with great difficulty, and put the machine back together. When I turned it to spin, ooo... what a difference... probably didn't work like that when it was new. But when I turned it to wash, after 30 seconds of filling, it started beeping, the drain pump turned on, and the end light turned on. checked all the wiring and pressure switch tubing and all little thingamabobs. I thought it was the heater but on rinse it does the same thing. Funny thing: when I disconnect the heating element, it will just fill until... well it just fills until I stop it or it overflows and does nothing else. well, during the last wash before the bearing service someone mentioned that the area around the circuit board got too hot. I pulled the board and found a lot of soot around some kind of transformer. the core of the transformer was cracked. I dug all over the internet for that transformer but I cannot find it. it is a hartu 716278-51. the board is an electrolux ewm1000. any help with finding the specs of the transformer or problem would be appreciated. I will post some pictures shortly.
Thanks
via AEG lavamat circuit board transformer
by vroomZOOM
No comments:
Post a Comment