Speed Queen replace tub bearings

complete tear down to replace tub bearings

via Speed Queen replace tub bearings
by tmol

speed queen

complete tear down to replace tub bearings

via speed queen
by tmol

No spin cycle

Whirlpool cabrio model not engaging in spin cycles was working on low spin only for about a week after high stopped working now nothing. Warranty is up, its had issues in past under warranty . Is it worth fixing, would have to hire someone not mechanically inclined here. Lid locks then during spin cycle flashes and no spin.

via No spin cycle
by Groovin13

GE gtw460asj6ww Top load washer won’t drain.

Will not drain. There’s a buzz noise when it tries to drain. When I removed the drain hose to check for clogs, the tub emptied. Removed pump and hose with no signs of any blockage. Is there a way to test the pump? Or a is there a valve deeper in that I should suspect?

via GE gtw460asj6ww Top load washer won’t drain.
by InvalidUsername

LA500MXW1 White-Westinghouse Washer trunnion stuck on shaft

Hello everyone. I need advice on how to get the trunnion off the shaft of the transmission. It’s stuck solid. I’ve tried a couple pulley setups and wd40 and PB Blaster to no avail. Anyone have any ideas or is it a cutoff and replace deal? Thanks

via LA500MXW1 White-Westinghouse Washer trunnion stuck on shaft
by Chada51

Clothes are still soaking wet after wash cycle

I have a Maytag top loader washing machine Model MVWC565FW1. After a cycle is ran, regardless of how big of a load, the clothes are still soaking wet, I can actually wring the cloths out by had and get quite a bit of water from them. I put the machine in diag mode and from what I can tell am getting a F0E5 code (Sensing blinks, then Rinse and Done blink). If I look that code up, says "unbalanced", I cleared the codes and ran a very small load again. Same thing. I changed the belt...

Clothes are still soaking wet after wash cycle

via Clothes are still soaking wet after wash cycle
by DanCruice

Whirlpool wtw5000dw1 locked light keeps flashing

Hey guys I'm stumped I need some help a month ago my kids broke the lid lock mechanism while playing in it and didn't feel tell me so after I replaced it, it worked fine for a little over a week. Then it started all over again with the lid lock light flashing. I've unplugged it for 10 min, I've done the 20 sec reset, and even have reset the master control with no luck of success. So any ideas would be much appreciated.

via Whirlpool wtw5000dw1 locked light keeps flashing
by Mvnke

Washing machine wont spin

I have a model# MUWC415EW1 fills washes but won't spin dry. Clothes still soaking wet.

via Washing machine wont spin
by Joe Sperzel